torsdag den 26. maj 2011

Week 22

Week 21

Jakob and Nasko explain the oscilloscope results. Emir and Zlatko explain where they had remade the soldering.

Jakob made a small program to show the basic function of the single digit display.

Nasko investigate deeper about the wind sensor.

We talked about to begin writing our rapport, and decide that we should begin writing rapport next week.

tirsdag den 10. maj 2011

Week 20

Nasko & Jakob worked for one day to find solution for ADC. Jakob finished the prototype of display at home, and Zlatko & Emir made some measurement on prototype display.

Week 19

















Here is our
"overall blog diagram for our project" 1 part :
















Part 2 of the
"overall diagram" A bigger picture can be found in a document on dropbox.

There was some kind of mess with our blogs, that’s why we decide that all in our group stays 10-15 min. after the day is over to write our blogs.



Week 18

After we investigate all thees subjects we decide to start up on 7 segment display, and Nasko started to investigate if a wind sensor was possible to make.

Jakob started to investigate the 7 segment display

Emir and Zlatko started to make overall Block diagrams for the project.

There is a full document of our meeting and decision in the DropBox

We got a new groupmember named Essa. He started invesigating alturnative ways to build wind and seven segment display.

Our Gantchart :

The hole Gantchar is in Dropbox

Week 17

We started to discuss what our group contract should contain. We had a meeting about what we would have in it. There is a document from the meeting in the DropBox folder.

mandag den 2. maj 2011

Week 16

The first day we got information and information about what our project should be.
We got the assignment to go home, and think about some ideas through the weekend.

We
met up in school after the weekend was over, with 3 ideas.
-The first idea was to build a self-heating coffee machine with a self regulating heatingelement, that could turn on and off by a temperature sensor.
-The second idea was to build a windmill that would supply power, for example to a car battery.
-The third idea was to build a 7 segment display (add on)

At the end of the day we decide to investigate thees three subjects.